Skip to Main Content

TR-4800E-BHP

GPIO Bulkhead Panel

The TR-4800E-BHP designed to work in conjunction with the TR-4800E (+BP16) tally router. This 2RU bulkhead panel takes the GPIOs from the rear DB37 connectors on a TR4800E(+BP16) and then translates the 48 General Purpose Outputs and 32 General Purpose Inputs each to 2-Pin terminal blocks. Five 6-foot (2 meter) cables are provided to connect form the TR-4800E to the BHP to allow remote placement of the bulkhead panel.

Wet and Dry modes are easily selected for each GPO and GPI via a slide switches and no rewiring required. All GPIO are broken out to 2-pin removable terminal blocks to allow easy wiring. Additionally the BHP has a cable strain relief bar runs across the middle of the panel to provide a tie point for the GPIO cables.

Features

  • General Purpose Output

  • Simple 2 wires for each GPO
  • Wet / DRY selection on a per GPO basis via a slide switch
  • 48 sequential Terminal blocks at the top of the BHP
  • Straight through connection to the TR-4800E VIA DB37 Connectors
  • Cable strain relief bar
  • GPO Terminal blocks are provided
  • General Purpose Input

  • Simple 2 wires for each GPI
  • Wet / DRY selection on a per GPI basis via a slide switch
  • 48 sequential Terminal blocks below the strain relief bar on the BHP
  • Straight through connection to the TR4800E VIA DB37 Connectors
  • Cable strain relief bar
  • GPI Terminal blocks are provided

Specifications

Connectors
Rear Input Connectors D37 Socket (From Tally Router)
Rear Output Connector D37 Socket (From Tally Router)
Rear Input Connectors 2 Wire Terminal Block on a per GPI basis
Rear Output Connectors 2 Wire Terminal Block on a per GPO basis
Provided Cables 5x DB37-M-to-DB37-F-6ft-Cable
Physical
Height 2RU, 88mm (2.5" nom.)
Width 19" rack mount
Depth 2" (51mm)

Ordering Information

TR4800-BHP GPIO Bulkhead Panel for TR-4800E

Can be ordered with TR-4800E or TR-4800E+BP16