************************************************************
*  This firmware is for the following product:             *
*----------------------------------------------------------*
*           7800SRG-IP                                     *
************************************************************

version b1114  May 2, 2022
--------------------------------------------------
Clean up some defaults.
Add a control for DSCP of PTP general messages (Announce messages)
FTP rmdir, mkdir and pwd commands work from a windows cmd box.  Slashes are not needed when changing directories.
Added unicast mode.  This allows slave to send delay requests in unicast mode.  The master must also be set to unicast mode, and IP settings must be correct.
Management messages are now forwarded to other ports.
Default password is now 7800

version b1030  January 15, 2021
--------------------------------------------------
Added a dither control
Added traps and syslogs showing ptp reasons for changes.
Added global phasing for sync outputs.
Added link state to menu.
Improved stability of PTP.

Added a get and dump command from the Presets menu to save and get presets to the file system.

fix the display of subnet broadcast address.  We don't use classes any more.
prevent mismatching SMPTE-2059 master modes from outputting data.
Now it preloads the SMPTE 2059 ltcs with local settings at boot.  This gives it a sane value if it is in SMPTE Master mode, but no management messages have arrived.
remove aborts that occur if the data rate is not set yet.
Fixed a bug which can cause the panel control to hang up if there are high Ethernet loads.

Added Grandmaster info to the status menu.
Adding last BMCA results to the status.
Fix a range display issue of Announce Timeouts.  MSC-450
Make the Syslog enable also turn on or off the syslog messages from the PTP engine.
Jams now work from VistaLink.
VistaLink cannot turn off SNMP enable.
Make the Syslog enable also turn on or off the syslog messages from the PTP engine.
Fix some spelling to make it closer to VistaLink.
Add syncro controls to VistaLink.
Fix ranges of phasing in syncs in VistaLink
Add 648 sync mode to VistaLink.
Remove 10G and Frame Ethernet controls in menu.
fix smpte 2059 frame rate.  Previously said 29.97DF.  now says 30.
Now outputs smpte-2059 metatdata with 23.98, 24, 29.97 and 30 fps content.
Europe (PAL) presets now includes SMPTE-2059 frame rate and drop frame.  Previously defaulted to NTSC rates.
Gor rid of some false NV sanity check warnings.
Added SMPTE 2059 output timing on LTC ad TG outputs.
Added a command to blink front red green leds for 10 seconds in VistaLink.
Added a command to read boot time in VistaLink.

version b776  March 23, 2020
--------------------------------------------------
Initial release