********************************************************* * This firmware is for the following products: * * -------------------------------------------- * * 7767VIP8-HSN, 7767VIP8-SN, 7767VIP8-HSN-G * ********************************************************* Version 1.10.3 (July 6, 2009) ---------------------------------- - Added graticule mode to follow source aspect ratio. - Added support to SNMP interface for setting the output refresh rate to 24Hz SF and 23.98Hz SF. - Added CCA support (ie. fault disable/enable/reset). - Added support for Video Index decode. -Corrected scaler artifacts. -Corrected Point release number sent to VLPro. -If aspect ratio adjust is set to videoindex and video loss occurs, then aspect ratio should follow the input aspect ratio. -Adjusted black detection noise threshold. -Modified freeze detection algorithm for improved performance with composite (NTSC/PAL) video sources. -Corrected cherrypicker trigger by GPI. -Added mode to TSL parsing for stripping leading/trailing spaces. -Corrected issue where the severity colours could not be changed. -Corrected duration for audio silence, mono, and phase reversal faults. -Corrected GPI SDI video route. -Onboard server: do not allow h/v post-scaling. Version 1.10.0 (December 27,2007) ---------------------------------- Features: * Support multiple sizes/copies of an input * Support for upstream routers controlled by MVP server * Extended character set to support Turkish language * Corrected WSS decode for 14:9 Letterbox Top and 16:9 Letterbox Top Version 1.9.8 (September 24,2007) ---------------------------------- - Support for 7767VIP8 platforms on new PCB (previous version did not properly support this product/PCB combination) - Implemented audio phase alarms in firmware code (was previously not done correctly) - Added WSXGA+ output resolution (1680x1050). - Added support for Harris variant of Image Video Protocol. Version 1.9.7(September 13, 2007) --------------------------------- Feature additions: * Added support for new VIP hardware (7700OV3). * Added support for EDID input on new hardware. * Added 1080P output mode that doesn't have HD-SDI output for increased background locking frequency range. * Various improvements in background input detection. * Added ability to route video to SDI using GPI. * Fixed a condition that would cause an FTP upgrade to fail. Version 1.9.5 (July 19, 2007) -------------------------------- - Added input crop feature. - Added 1080p warp output resolution. - PAL 48Hz genlock added for 24/23.98 support. - Reduced vertical aliasing artifacts for 525i/625i SD-SDI output modes Notes: GDAC Warp 1.1 build 228 or greater must be used for the VIP's 1080p warp output resolution. Version 1.9.4 (March 06, 2007) ---------------------------------- Feature: -1080i over HD-SDI output while using the 1920x1080p resolution for the DVI/VGA and GLINK output. Version 1.9.3 (January 26, 2007) ---------------------------------- - Added video input properties control to the HTTP interface. Version 1.9.2 (December 21, 2006) ---------------------------------- - Changes to WUXGA timing for improved GDAC compatibility. - Improvements 525i and 625i input locking. Version 1.9.1 (October 18, 2006) ---------------------------------- - General improvements made to the overall video processing engine Version 1.9.0 (September 22, 2006) ---------------------------------- Feature: - Added the ability to scale the DVI input as an independant video source. BugFix: - Improvements to the clock rendering. Clocks now tick at an acceptable rate. - Improvements made to the layout load times. Layouts load at a conistent rate across all VIP verisions - AES audio outputs were repeating AES output 1 across all outputs. Fixed so that all AES outputs uniquely output AES from the appropriate channel. Version 1.8.3 (May 24,2006) ---------------------------------- - added user bit rate control to throttle thumbnail transmission Version 1.8.1 (April 20, 2006) --------------------------------- - correction to video freezing when full screen output in 1080i Version 1.8.0 (April 18, 2006) --------------------------------- - added 4 UMDs support - added support for Cascaded Systems - added support for 3000DCP - added support for third party control - added VIP/MVP system integration support via an external server - added Input Format Detection Status Labels - added WSS Detection Status Labels - added Program Rating Status Labels - added severity control for video object - added WXGA2 (768x1366) Warp support Version 1.7.3 (March 23, 2006) --------------------------------- - added black and white composite video asvalid video standard Version 1.7.1 (January 18, 2006) --------------------------------- - added 2 groups ofaudio support - enabled all 4 AES monitoring outputs Version 1.7.0 (December 14, 2005) --------------------------------- - First Release