*********************************************************
* This firmware is for the following products:          *
* --------------------------------------------          *
* 7735CEM, 7735CEM-A4, 7735CEM-AES                      *
*********************************************************

Version 1.06 build 12 (June 15, 2006)
-------------------------------------
- correction to video outputs when using external AES

Version 1.5 build 2 (March 10, 2006)
-----------------------------------------
- correction for PAL-B colour frame locking
- added Audio SRC reset
- correction to the Audio demux

Version 1.03 build 4 (September 27, 2004)
-----------------------------------------
- fix for CRC miscalculation on AES outputs

Version 1.02 build 10 (May 04, 2004)
------------------------------------
- fix for minor timing issue

Version 1.02 build 9 (May 14, 2003)
-----------------------------------
- fix for setting audio source to AES in VistaLink Pro software
- corrected V delay reported in VistaLink Pro software not matching V delay reported in
  card menu system 
- fix for Audio Missing 3/4, EDH AP, EDH FF traps having their polarity reversed

Version 1.01 build 248 (April 4, 2003)
--------------------------------------
- added audio routing support to the -A4 and -AES flavours of the CEM
- added audio gain support to the -AES flavour of the CEM
- added loss of audio duration support - fault trigger only becomes active if audio is   missing for the specified duration
- added EDH detection - **NOTE** Hardware build 1 does not support EDH detection
- added support for PAL colour phase
- VistaLink enabled all 7735CEM-XXX parameters
- fix for Loss-of-Video mode

Fix for the operation of the fault status screen in the CEM:
- "AES" has been replaced by "audio pair"
- "DARS" is displayed only in the -A4 and -AES flavours
- "video fine phase" has been replaced by "525 fine phase" and "625 fine phase".
- a factory reset results in "loss of audio 1/2" and "loss of audio 3/4" driving fault 2
- when operating in "fault" mode, "loss of audio x/y" faults can drive the display   properties (colour and opacity) of the "ch x/y" status window line


Version 1.0 build 932 (September 10, 2002)
------------------------------------------
- Allows VBI to be passed
- Corrected Color frame sequence

Version 1.0 build 926 (August 9, 2002)
--------------------------------------
- first release